8
AC output
1
Turn on the main power supply.
2
Press the AC output switch. After that, the
120 V AC output is turned on, the AC
socket starts to output power supply, and
the AC switch indicator is turned on.
3
Press the AC output switch again. After
that, the 120 V AC output is turned off,
and the AC output switch indicator is
turned off.
When the output of AC port is
less than 15 W for 12 hours continuously,
the AC output switch will turn off
automatically.
You can press the AC output switch during AC charging to turn on the AC output to enter the EPS
mode, and then the AC socket can take power supply directly from the AC input port. In this case,
the power of charging and 120 V AC output cannot exceed the limit power of AC input (peak
value < 1200 W); otherwise, the AC input may be disconnected for protection. In EPS mode,
when the AC output power exceeds 850 W, the AC input cannot power the battery, and
meanwhile the maximum AC output power is 950 W. In EPS mode, once the power supply fails
due to abnormal AC input, the product immediately switches to battery power supply within 30
ms.
During DC charging, the 120 V AC can still output power supply normally, that is, charging and
discharging can be performed simultaneously.
After the AC input charging port is connected to the mains:
1.
In power-off state, the product wakes up automatically and charges the battery in
accordance with the preset charging power.
2.
When the 120 V AC output is operating properly, it will switch to EPS mode for power supply
and start charging the battery at approximately 250 W.
You can press the fast
charging switch to cycle
between low-rate
charging and fast charging
of AC input. After the
power supply is turned
on, low-rate charging is
performed by default.
2. AC charging
