Important
Before removing Cup Nº02 (Fig.01), check if the motor is completely stopped,
otherwise accidents and damages to your product may occur.
3.1 Starting
To start machine use ON/OFF switch Nº06 (Fig.01) located on Motor
Housing Nº04 (Fig.01).
3 . Operation
Observation
The necessary processing time will be different for each kind of
IMPORTANT
NEVER SWITCH ON THE MACHINE BEFORE LOADING ITS
BOWL , BECAUSE IRREPARABLE DAMAGE WILL RESULT .
3.2 How to Feed the Blender
The TA-04 Blenders are machines working at high speed ( approximately
22,000 rpm off load ) .
To feed it observe the following instructions :
Cut the product in small pieces , about 1.5 inches wide , such precaution helps
to decrease the blending time process , mainly when working with frozen products . When
working with ice it is recommended to join a little water .
Withdraw the Lid No.01 (Pic.01) .
Place the product inside the Bowl No.02 (Pic.01) .
Close the Bowl with the Lid , and Switch ON the machine .
3.3 Cleaning
Important
Never clean the machine when plugged to the electric network . Before
cleaning , withdraw the plug from the socket .
Before to withdraw the Bowl be sure the motor has stopped completely .
Watch out any abnormal noises coming from the motor or any moving parts .
Check the safety devices to be normally operating .
4.3 Routine Inspection
4.2.2 Advices
The instructions of the this Manual shall be perfectly understood .
All function or procedure shall be perfectly clear .
Any manual ( button , pulse ,electric switch or lever ) command shall be
given only after to have the complete assurance it is the right command .
4.2.3 Cares
The electric cord , used to feed the electricity to the machine must have the
right section to be able to support the machine motor power rating . Any electric wiring
running over the floor near the machine shall be duly protected to avoid short circuits .
06
03
Important
Blenders equipped with OVERLOAD SWITCH, code 25800.8 with serial number
up to 31 will be turned OFF automatically if there is an excessive temperature
increase. When it happens turn ON/OFF switch to OFF position immediately and
disconnect plug from wall socket as the Blender will turn ON AUTOMATICALLY
WHEN THE TEMPERATURE COOLS DOWN, WHICH MAY CAUSE ACCIDENTS.
Wait for minimum 15 minutes before turning Blender ON again. In case motor
does not start after the Blender has been turned ON, turn it OFF immediately and
disconnect plug from wall socket and call your Distributor for technical
assistence.
