26 von 84
Stand 21.2.2020
DE
EN
FR
NL
IT
ES
PL
ASSEMBLY AND PREPARATION FOR OPERATION
1. Remove all packaging materials. Keep packaging materials away from chil-
dren - danger of suffocation!
2. Clean all parts with a damp cloth, as described in the chapter “Cleaning
and care”.
3. Push the legs (11) through the holes in the tray (10).
4. Set up the stand, and if necessary turn the stand legs to that the appliance
stands stably. If necessary, push the end caps for the legs into position.
5. Push the pipes (9) up into the holes in the tray.
6. Press the insert (7) onto the stand by applying pressure to it.
7. Fix the spacers (6) into the recesses provided for this purpose on the insert.
In doing so, the side with the three openings must face upwards.
8. Insert the provided handles (12) in the grill housing insert (8) by pressing
them from below in the respective groove, until the clutch engages.
9. A sure transport of the device is guaranteed by the handles.
10. Fit the side tray (7) by pushing the wider side of the side tray onto the cor-
responding holder on the insert.
11. Place the water tray (5) onto the opening in the insert. Please ensure that
the two openings on the water tray face upwards on the insert as a recess for
the heating element (4).
12. Ensure that the grill table is stable.
Fill the water tray with at least 1.300 ml of water. Never operate
the grill without first filling the water tray.
13. Insert the heating element (4). The insert is correspondingly recessed for
the control unit. Please insert the heating element very firmly, as otherwise
the built-in safety switch on the lower side of the control unit prevents the
appliance from being switched on.
14. Place the grill plate (3) into position.
15. Push on the wind shield (2); for this, the notches on the wind shield must
point downwards. If required, now push the small gridwork shelf (1) into
position on the wind shield.
16. Check to make sure that all parts have been assembled correctly.
17. Connect the appliance via the power cable to the power supply (AC, 230 V~,
50 Hz).
Copyright UNOLD AG | www.unold.de