18
2. You obtain the best results with dry hair. Consequently
dry your hair thoroughly with hair dryer before using the
curler.
3. Brush your hair until it falls loosely.
4. If necessary protect your hair with a heat protection
product.
OPERATION
1. Prepare your hair as described in the chapter “Before
using the appliance”.
2. Plug the power cord into an electrical outlet.
3. Switch on the appliance via the ON/OFF switch by kee-
ping it briefly depressed. The indicator light shows that
the appliance is in operation.
4. The heat-up time is approx. two minutes.
5. Divide combed hair into small strands that should not be
more than 2 centimetres thick. If necessary separate the
hair strands with a bobby pin.
6. Open the clip and place the
end of the hair strand on the clip
closure point in the lower end of
the hair rail.
7. Release the clip, the hair
strand is fixed in place.
8. Wrap the hair strand in the
direction of the scalp by turning
the curler to the inside.
9. If hair becomes tangled when winding it up, turn the
curler in the opposite direction to loosen the hair and
start over again.
10. Leave the hair strand wrapped around the curler until the
hair strand is warm to the touch. Through curling trials,
you can quickly determine the curling time that is right
for your hair. If you leave your hair in the curler for a short
time you will have gentle curls, if you leave your hair in
the curler for a somewhat longer time you will have firm,
springy curls. The maximum time should not exceed 20
seconds, to prevent damage to
your hair.
11. Open the clip again. Now you
can simply remove the curl out of
the curling rail.
Copyright UNOLD AG | www.unold.de
