unotec ReSound, Manual

8

Manual

Thank you for your interest in our wireless headphones UNOTEC 

ReSound.

Installing the receiver

Insert 2 AAA batteries (not supplied) into the side of the headphones.

Installation transmitter

Insert 2 AAA batteries (not supplied) into the lower compartment.

Connect the audio cables (red-white) to an audio source such as 

TV-out, music player, DVD, CD, MP4, etc. In the case that the audio 

output device is a cable jack adapter cable sumistrado use as shown 

in Figure 1. To improve reception unroll emitter cable so that it acts as 

an antenna.

Wireless function

1) After installing the receiver and connected to an audio source (re-

member to plug into an outlet and not an audio input) place the button 

on the transmitter WIRELESS EARPHONE position. A red light should 

turn on the transmitter.

2) Turn the volume button on the headset until it clicks and the red indi-

cator light. Then press the RESET button once. This places the receive 

frequency at the beginning of the band. Now press SCAN key once to 

tune the frequency of the same issuer.

Wireless Chat

1) Connect the power adapter to the transmitter (Figure 2) and the other 

end to the audio output of the PC. In turn connect the cable jack-jack 

output microphone transmitter to the PC microphone

2) Place the transmitter with the microphone facing you (Figure 3) and 

place the transmitter button on the AUDIO CHAT position. The red light 

will come on.

3) Turn the volume button on the headset until it clicks and the red 

indicator light. RESET and then press the SCAN button to tune in the 

same fecuencia the issuer.

Monitor

Place the transmitter in the room or place you want to monitor (listen). 

Push the button on the receiver to monitor and the red light will light 

emitter. Turn the volume button on the headset until it clicks and the red 

indicator light. RESET and then press the SCAN button to tune in the 

ENGLISH