English
10
The digital control panel SpidoTouch used in SpidoCook™ digital grills is designed to alert the user to possible
error messages or failure.
If there is any warning or allarms push the button to slide them.
Warning messages:
When a malfunction is detected which allows the appliance to continue operating, abeit in a limited manner,
a WARNING message is displayed. The device continues to run and the WARNING message remains on
the display until any operation button is pressed.
From the normal view, to verify the presence of any warning, hold for 5 seconds the buttons
and
simultaneously. It is possible to make this operation just if the grill is not working.
DISPLAY
MESSAGE
Description
Effect
Problem solution
W01
The temperature of the appliance
power P.C.B. is too high
The appliance continues to operate
but there is a risk of permanent
damage to the power P.C.B.
Contact the Customer Assistance
Service
W02
The temperature of the appliance
control board is too high
The appliance continues to operate
but there is a risk of permanent
damage to the control board
Contact the Customer Assistance
Service
W10
Basic control board setting error
The appliance keeps on working
(with some limitations due to the
setting involved on the error)
Contact the Customer Assistance
Service
Allarm messages:
When a condition arises which prevents the appliance from operating at all, an ALARM signal is displayed and the
appliance must be switched to its STOP status. The device stops operating and the ALARM! message appears
on the oven display until the problem is resolved. If the device is operating when the ALARM status occurs, it
will shut down and the alert corresponding to the detected problem will be displayed. To resolve a problem of
this type, contact an Authorised Assistance Centre. Once the problem has been resolved, the appliance can be
reactivated by pressing the «START» button.
DISPLAY
MESSAGE
Description
Effect
Problem solution
A01
Temperature probe alarm
Appliance shutdown
Contact the Customer Assistance
Service
A02
The safety thermostat has overheated
(intervenes if the temperature rises
too quickly or when it reaches 370 ° C
Appliance shutdown
Contact the Customer Assistance
Service
Maintenance in case of failure:
In case of failure, in case of failure, failure of the ceramic surface or in case of occurrence of cracks,
immediately disconnect the unit from the mains and call a service center for replacement of glass.
Oven-user communication
