u25w Setup Guide
Package Contents
The u25w package includes:
●
Power adapter
●
Antenna
●
Ethernet cable
●
u25w appliance
u25w rear and front panels
Rear Panel
Front Panel
DC Jack
Power input
Console
Console port
HDMI
HDMI port
USB3.0
USB3 port
USB2.0
USB2 port
LAN1
Internet port
LAN2
LAN port
LAN3
LAN port (not configured)
RESET
Reset switch
Power button / indicator
Installation
●
Connect the ethernet cable from your Internet modem or router to the Internet port (LAN 1) located on the rear panel.
●
Connect the ethernet cable from your LAN switch to the LAN port (LAN 2) located on the rear panel.
●
Fasten the included antenna to the WiFi RP-SMA connector located on the rear panel.
●
Plug in the power adapter to a power source and connect it to the power input located on the front panel.
●
Review the power button on the front of the appliance. If the indicator is green, the appliance is powered on.
●
If the appliance is not powered on, press the power button.
Connect to the appliance
You can connect to your appliance via the online
Command Center
portal at
. Alternatively, you can connect to your
appliance from the local network, or directly using a monitor, keyboard, and mouse.
Via Command Center
Provisioning a new u25w appliance via Command Center is a convenient way to deploy and configure NG Firewall. To set up and manage
your new appliance from Command Center follow these steps:
| © Copyright 2018. Untangle, Inc. All rights reserved.
u25w Setup Guide - Page 1
