Scales - Models 410 and 520
— Set Up
2-8
Axle Load Cell Installation
•
BEFORE PROCEEDING, REFER “GENERAL SET UP” PAGE 2-3 FOR PROPER WARNINGS.
1. With the cart empty, use a safe lifting device with a minimum weight rating per chart to sup-
port the weight of your grain cart. Place the safe lifting device under the axle, near the tire.
• Replace only 1 spindle at a time.
2. Remove wheel and tire. Refer to maintenance section for wheel removal and replacement
procedures.
3. Starting on the left-side of the cart, remove the bolt and lock nut that retains the spindle
to the axle. Using a lifting device rated for 150 lbs, replace the spindle. Coat axle contact
length of spindle shaft with anti-seize lubricant prior to installation. Install with ‘top’ decal
facing upwards. Reuse bolt and lock nut to retain spindle to axle.
4. Using a 200 lbs. rated lifting device, re-install hub assembly, removed in Step 2, onto spindle.
Install outer bearing, spindle washer and castle nut.
5. Attach the wheel(s) and tire(s) to the hub using the same rated lifting device for removal.
Tighten wheel nuts to appropriate requirements and recheck as outlined in the Wheel and Tire
section of this manual. Raise cart, remove safe lifting device and lower tire to the ground.
6. Repeat steps 2 through 5 on right-side of the cart.
SAFE LIFTING DEVICE WEIGHT
Brent Models:
472, 572, 576, 678, 774, 776,
780, 782, 874, 876, 880, 882,
V700
12,000 Lbs.
1080, 1082, V800, V1000
14,000 Lbs.
V1100
16,000 Lbs.
1194
20,000 Lbs.
1282
22,000 Lbs.
1394
24,000 Lbs.
Unverferth Models:
5225, 6225
7,000 Lbs.
760, 7250
9,000 Lbs.
860, 8250
10,000 Lbs.
1060, 1160, 9250
14,000 Lbs.
1015, 1017, 1110, 1115
16,000 Lbs.
1019, 1315
18,000 Lbs.
1119, 1310, 1319
24,000 Lbs.
SAFE LIFTING DEVICE WEIGHT
Killbros Models:
735, 1150, 1160
9,000 Lbs.
835, 1175, 1185
10,000 Lbs.
1035, 1135, 1195, 1950
14,000 Lbs.
Parker Models:
524, 624, 742
9,000 Lbs.
739, 839, 842
10,000 Lbs.
1039, 1042, 1048, 1139, 1142
14,000 Lbs.
1152
16,000 Lbs.
1352
24,000 Lbs.
Scale Kit Installation — 3-Point Scales with Spindles
(continued)