Scales - Models 410 and 520
— Set Up
2-9
Scale Kit Installation — 3-Point Scales with Compression Cells
Hitch Assembly
1. Remove the snap rings and pins to remove cast hitch. Retain hardware removed.
2. Remove capscrew, lock washer and nut to remove hitch bar. Retain hardware removed.
3. Replace with scale hitch bar into the hitch bushing, making sure to feed the scale wire through
the hitch bushing also.
NOTE: The bending direction decal on the end of the bar should point up. Also, the hitch bar
should be installed with the serial number decal facing up.
4. Reusing the capscrew, lock washer and nut, assemble the scale hitch bar to the tongue.
5. Reattach the cast hitch to the scale hitch bar using hitch pin and snap rings.
NOTE: Some carts require removal of original hitch bushings. The single large bushing supplied
is installed first, followed by routing of the scale hitch bar cable through the tongue bushing exit
hole, then installing the scale bar with bending direction decal on the end of the bar pointing up
with the serial number decal facing up.
FIG. 2-2
Brent Models:
782 with Single & Dual Wheel/Tires
(Serial Number B26270099 - Lower)
Replace Standard Hitch with Scale Hitch Weigh Bar 2 7/8” Dia. (9004903)
782 with Single & Dual Wheel/Tires
(Serial Number B26270100 - Higher)
Replace Standard Hitch with Scale Hitch Weigh Bar 3 3/4” Dia. (9004910)
780, 880, 1080 with Single &
Dual Wheel/Tires & Tracks
Replace Standard Hitch with Scale Hitch Weigh Bar 2 7/8” Dia. (9004903)
882, 1082
with Single & Dual Wheel/Tires
Replace Standard Hitch with Scale Hitch Weigh Bar 3 3/4” Dia. (9004910)
1082 with Tracks
(Serial Number B31270099 - Lower)
Replace Standard Hitch with Scale Hitch Weigh Bar 3 3/4” Dia. (9004910)
1194 with Tracks Manual Tension
Replace Standard Hitch with Scale Hitch Weigh Bar 3 3/4” Dia. (9004910)
Unverferth Models:
9250 with Tracks Manual Tension
Replace Standard Hitch with Scale Hitch Weigh Bar 2 7/8” Dia. (9004903)
1110 with Tracks Manual Tension
Replace Standard Hitch with Scale Hitch Weigh Bar 3 3/4” Dia. (9004910)
Parker Models:
1152 with Tracks Manual Tension
Replace Standard Hitch with Scale Hitch Weigh Bar 3 3/4” Dia. (9004910)