Scales - Models 410 and 520
— Set Up
2-18
Axle Load Cell Installation
•
BEFORE PROCEEDING, REFER “GENERAL SET UP” PAGE 2-3 FOR PROPER WARNINGS.
1. With the cart empty, use safe lifting device with a minimum weight rating per chart to sup-
port the weight of your grain cart. Place the safe lifting device on undercarriage rear of the
axle.
• Replace only 1 bar at a time. Follow Steps 2-5 before loosening hardware on any of the other bars.
2. Starting on the left side of the cart in front of the axle, remove capscrews, flat washers, lock
washers and hex nuts connecting the axle mount weldment.
NOTE: The bending direction decal on the end of the bar should point up. Also, the hitch bar
should be installed with the serial number decal facing up.
4. Remove snap rings and pins retaining both ends of the non-scale bars.
5. Replace non-scale bars with scale bars using snap rings and pins removed in step 3 to connect
scale bar to axle and axle mount weldments
.
6. Reattach capscrews, flat washers, lock washers and hex nuts removed in step 2 to connect the
axle mount weldments to the cart frame
.
7. Route scale wires along axle and cart frame to location of J-Block installation.
Scale Kit Installation — 5-Point Scales
(continued)
Walking Tandems / Steerable Tandems / In-Line Tandems
SAFE LIFTING DEVICE WEIGHT
Brent Models:
1194, 1196
20,000 Lbs.
1282, 1394, 1396
24,000 Lbs.
1594, 1596, 2096
28,000 Lbs.
Unverferth Models:
1110, 1119
16,000 Lbs.
1019, 1115, 1117, 1120
20,000 Lbs.
1315, 1317
22,000 Lbs.
1310, 1320
24,000 Lbs.
1319
26,000 Lbs.
1519
30,000 Lbs.
2020
34,000 Lbs.
SAFE LIFTING DEVICE WEIGHT
Killbros Models:
1113
20,000 Lbs.
1111, 1311
22,000 Lbs.
1313
24,000 Lbs.
Parker Models:
1152
16,000 Lbs.
1154
20,000 Lbs.
1348, 1352
22,000 Lbs.
1354
24,000 Lbs.