4
Driver Installation Procedure
When plug in UT-792I, system pops up a window, select
Install
from list or designated location
and click
Next
A program path selection installation window will pop up
as illustrated below. Select
Search in these locations for the
best matching driver , then
Search include this location
,
click
browse
and select the folder in the disc. If your operation
system is XP, the select Win2KXP foler. If other systems, select
the corresponding folder and clieck
Next
.
Install drivers for the remaining ports following the procedures
above.
After drivers are installed, open device manager and check if there
is any virtual COM port under port tag. If there is not other port driver
installed in the system before, the default COM ports are COM3, 4,
as illustrated below. All drivers have now been installed on UT-792I.
5
6
After located and installed the driver, clieck
Finish
.
New hardware wizard dialog box will pop up again, and drivers
for the 3 serial ports need to be installed. Select
installation
from the list or designated location and click
Next
.
