upcom UC-120-FWA, Assembly Manual

14  |  UC-120-FWA ASSEMBLY MANUAL

4 

Maintenance

MAINTENANCE OVERVIEW

After installation, the antenna requires only periodic inspec-
tion. It is anticipated that maintenance, if required, will be 
minimal and easily handled by a local or inhouse maintenance 
staff.

REFLECTOR

Antenna reflector does not require any maintenance. The com-
posite construction of the reflector is virtually impervious to 
any damages that could be caused by weather or atmospheric 
conditions.

It is only necessary to inspect for any physical damage done by 
vandalism or very severe weather conditions.

Should any damage be detected to a portion of the reflector, 
contact the Customer Service Department at UPCOM for 
recommendations involving reflector repair.

MOUNT AND REFLECTOR SUPPORT STRUCTURE

The mount and reflector support structure supplied with this 
antenna is of aluminum construction and has a painted finish.

Elevation and Azimuth adjustment screws are made of stain-
less steel.

If there are any signs of structural failure, the mount members 
that are damaged should be repaired or replaced.

CORROSION: Any corrosion on steel members may be re-
paired with a cold, zinc-rich galvanizing paint.

Note: Rust on the edges of stamped metal parts is normal and 
will not adversely affect the structural integrity of the antenna 
system.

FEED AND FEED SUPPORT

The feed support and feed rods should be inspected to insure 
that all hardware is secure.

The feed/radio mounting bolts should be tight.

The feed horn window should be inspected to insure that it is 
intact so that no moisture can collect inside the feed horn.