background image

Subject to change without notice. Printed in U.S.A.

10757-UAI-B-1204

Copyright

 ©

 by Unitary Products Group 2004. All rights reserved.

Supersedes: 10757-UAI-A-0602/035-13073-001-A-0602

Unitary

5005

Norman

Products

York

OK

Group

Drive

73069

Summary of Contents for 1HA0409

Page 1: ...aving jurisdiction If the information in these instructions is not followed exactly a fire explosion or production of carbon monoxide may result causing property damage personal injury or loss of life The qualified agency performing this work assumes responsibility for the proper conversion of this appliance with this kit For U S units installation must comply with the National Fuel Gas Code ANSI ...

Page 2: ...as were disconnected in Step 2 and 3 or refer to the unit wiring diagram 14 Mark the appropriate data burner orifice size manifold pressure and heat exchanger input capacity on the conversion labels provided and install them adjacent to the unit data plate 15 Refer to the Gas Heat section of the unit installation instructions for proper installation and start up proce dures TESTS AND ADJUSTMENTS A...

Page 3: ...er orifices where they thread into the manifold Repair any leaks found and recheck DO NOT CHECK WITH OPEN FLAME 11 With main burners off disconnect the manometer and replace the manifold plug Check for gas leaks at this plug 12 Remove jumpers and replace all access panels Manifold pressure for the respective BTU HR input or out put must be adjusted to the IWG as specified on the ori fice label 035...

Page 4: ...ge without notice Printed in U S A 10757 UAI B 1204 Copyright by Unitary Products Group 2004 All rights reserved Supersedes 10757 UAI A 0602 035 13073 001 A 0602 Unitary 5005 Norman Products York OK Group Drive 73069 ...

Reviews: