PARTS LIST
SPECIFICATIONS
1 stove assembly
TYPE: “Airtight” cast iron
legs
HEIGHT:
30 inches
2005 baffles (L and R) WIDTH:
18.5 inches-
4 1/4 inch washers
LENGTH:
31.5 inches
4 1/4 inch nuts
SHIPPING
6005 stove hoe
WEIGHT:
300 lbs.
6001 spark guard
FINISH:
11000 flat black
6011 stove handle tool FUEL: seasoned hardwood
maximum length 26”
HEATING CAPACITY: 50,000 BTU
PIPE SIZE:
7” dia. 26 Ga.
**READ ALL INSTRUCTIONS CAREFULLY BEFORE
ATrEMPTING ANY INSTALLATION
**READ OPERATIONS SECTION FOR SAFETY PRECAUTIONS
BEFORE OPERATING YOUR STOVE
NOTE: THIS UNIT IS NOT FOR USE IN MOBILE HOMES
ASSEMBLY INSTRUCTIONS
1.Remove the stove and parts from the carton and check for any damage
that may have occurred in shipping. Check the parts against the parts
list to make sure that all the parts needed to assemble the stove are
included.
2.Lay the stove on its back and install the legs (part #2002) by placing
the leg against the locating bar on the bottom of the stove so that the
threaded rod protruding from the bottom of the stove is in the slot in the
leg (see diagram on last page). Fasten the leg using the washer and nut
provided in the small parts bag. Tighten the nut snugly, but do not
overtighten. After the stove has been fired and cooled check the leg nuts
for tightness.
