© UPLIFT Desk
• 800-349-3839 • info@upliftdesk.com • upliftdesk.com
3
Step 7 (Bolt-Through Method)
A. Lower the Base assembly to the desktop guiding
the Long Bolts through the desktop hole(s).
B. Slide a Lower Base Plate onto each Long Bolt and
secure it against the desktop with one D8 Washer
and one M8 Nut.
C. Tighten each M8 Nut with the Flat Wrench. If
you utilized one large hole instead of two smaller
holes, ensure the Lower Base Plates straddle the
hole while you tighten the M8 Nuts.
D. Proceed with the Arm Assembly, Step 8.
Arm & Tray Assembly
Step 8
Slide the Arm into the Base until it is fully seated and
tighten the set screw shown with the 3mm Allen
Wrench. This will secure the Lower Arm to the Base
and keep it from becoming separated during adjust-
ment.
Step 9
Peel the backing off of each Tray Pad and place them
on the bottom of the tray, close to each corner.
Step 10
Connect the Tray Mount to the Tray by using the
two M6x20 screws and tighten using the 4mm Allen
wrench.
Step 11
Slide the Tray assembly onto the post at the top of
the Arm. Tighten the set screw shown with the 3mm
Allen Wrench. This will secure the Tray assembly to
the Arm and keep it from becoming separated during
adjustment.
