13
SYNCHRONISATION
Automatic Learning Function
1. After batteries have been inserted into the temperature/humidity sensor,
wind gauge, rain gauge and receiver, the learning function will automatically
begin and runs for approximately 3 minutes.
2. Within these 3 minutes, the receiver will begin to read the temperature &
humidity signals and displays the readings.
Manual-Learning (Searching for Remote Signals)
If a new remote sensor is added, or if the signal is lost (WT440H is blinking),
the learning function must be completed again.
1. Press and hold CHN on the receiver (Diagram A [4]) for 3 seconds.
2. A beep sound indicates that the learning function has started.
3. The ‘OUTSIDE’ symbol will flash, and the unit will beep as each remote sensor
is detected.
4. Temperature & humidity readings of the remote sensor, wind direction, wind
speed and rainfall readings will be displayed on the receiver.
Note: The Auto/Manual Learn Function will not operate while the radio controlled
clock is receiving signals. (LCD radio antenna will be flashing)