TROUBLESHOOTING
31
Wait for about 1-2 minutes to ensure the units are not in a
phase change. Otherwise, re-synchronize receiver by
holding the CHN "Channel" button for 3 seconds until a
beep is heard.
Ensure the remote sensor is out of direct sunlight, and away
from other sources of heat.
- Repeat the learn procedures. (see synchronisation section)
- Temperature may be below -30°
C.
- Batteries in
transmitter
may need changing.
- Move
the transmitter
closer to the receiver.
- Make sure
transmitter
is away from
solid obstacles or
sources of electrical disturbance.
Make sure you have correctly aligned the north marking
underneath the wind gauge's cap, with a compass, as true
magnetic North.
The temperature readings
of the transmitter and receiver
do not match.
Transmitter temperature
readings seem to high.
The receiver stops receiving
remote data or the display
is incorrect.
The wind gauge does not
display the correct wind
direction.
Problem
Solution
