2 | uponorpro.com
Important safety information
Warning
It is your responsibility to ensure that this control is safely installed according to all applicable codes
and standards. Uponor is not responsible for damages resulting from improper installation and/or
maintenance.
Radio frequency interference
The installer must ensure this control and its wiring
are isolated and/or shielded from strong sources of
electromagnetic noise. Conversely, this Class B digital
apparatus complies with Part 15 of the FCC Rules and
meets all requirements of the Canadian Interference-
Causing Equipment Regulations. However, if this
control causes harmful interference to radio or television
reception, (determined by turning the control off and
on) try to correct the interference by re-orientating or
relocating the receiving antenna, relocating the receiver
with respect to this control, and/or connecting the control
to a different circuit connected to the receiver.
Single-zone snow melt control installation and operation manual is published by
Uponor Inc.
5925 148th Street West
Apple Valley, MN 55124
USA
T 800.321.4739
F 952.891.2008
uponorpro.com
© 2017 Uponor. All rights reserved.
Second Edition
Second printing August 2017
Printed in Canada
Uponor Ltd.
6510 Kennedy Road
Mississauga, ON L5T 2X4
CANADA
T 888.994.7726
F 800.638.9517
uponorpro.com
Uponor has used reasonable efforts in collecting, preparing and
providing quality information and material in this manual. However,
system enhancements may result in modification of features or
specifications without notice. Uponor is not liable for installation
practices that deviate from this manual or are not acceptable
practices within the mechanical trades.
To avoid serious personal injury and damage to the equipment:
• Read manual and all product labels before
using the equipment. Do not use unless
you know the safe and proper operation
of this equipment.
• Keep this manual available for easy access
by all users. Replacement manuals are
available at
uponorpro.com
.
• Disconnect all power before opening
the control.
• Safely install this control according to all
applicable codes and standards.
Improper
installation and operation of this control
could result in damage to the equipment
and possibly even personal injury or death.
• Only place controls that are intended and
certified as safety limits into the control
circuit. This electronic control is not intended
for use as a primary limit control.
• Do not attempt to service the control. There
are no user serviceable parts inside the control.
Attempting to do so voids the warranty.
