9.8
Display room thermostat status
To display thermostat and actuator status of a room:
Icon
Description of use
Screen example
Stat call
Yes
: thermostat is calling for
heating (or cooling).
No
: thermostat is reporting
that room temperature is OK.
Act.
Open
: actuators are
powered and open or on
delay and will open soon.
Closed
: no power to the
actuators, which are closed
(or closing).
Min.
Minimum set point of room
is set at 20 °C.
Max.
Maximum temperature set
point of room is set at 26 °C.
9.9
Select heating or cooling mode
To select heating or cooling mode:
System Status
Heating or cooling
mode is activated for
the whole system.
Room Cooling
Enable
: Cooling the
room is allowed.
Disable
: Cooling the
room is not allowed.
9.10 Use holiday mode
Use holiday mode to set a common temperature reduction for all
rooms for a specifi ed time. The thermostat settings are ignored
during this period.
The reduced holiday set point applies to all installed room
thermostats. The setting range is 5 to 35 °C.
The minimum and maximum thermostat limitations have priority
over the holiday mode. For example, if the maximum/minimum
temperature range of a room thermostat is set to 20 °C to 25 °C,
and holiday mode temperature is set to 15 °C for all rooms, the
temperature for this room will not go below 20 °C.
Floor sensor thermostat settings have priority over holiday
mode maximum and minimum limitations.
To apply holiday mode:
1 On the Uponor screen, select
Main Menu > Holiday
Mode > Apply Holiday Mode
.
2 Enter the time and date for the start
of the holiday period and press
OK
.
3 Enter the time and date for the end
of the holiday period and press
OK
.
4 Enter the holiday temperature set
point and press
OK
.
The
icon on the main screen
indicates that the system is in holiday
mode.
To cancel holiday mode:
1 On the Uponor screen, select
Main Menu > Holiday
Mode > Cancel Holiday Mode
.
2 Select
Yes
and press
OK
.
9.11 Assign room name
The digits at the beginning of the room name on the display
mean:
• 1
st
digit – controller number (1, 2, 3).
• 2
nd
and 3
rd
digits – number of the fi rst channel controlled by
the thermostat (01, 02, 03, and so on). If several channels
are controlled by the thermostat, only the lowest channel
number is displayed.
To assign a room name:
1 On the Uponor screen, select
Main Menu > Settings >
Rooms > Room names
.
2 Select the desired controller (applies
only when more than one is installed)
and press
OK
.
3 Select the desired room or thermostat
and press
OK
.
4 Select the room name from the list
and press
OK
.
3 8
U P O N O R C O N T R O L S Y S T E M – I N S TA L L AT I O N A N D O P E R AT I O N M A N U A L
UK English
