Uponor Smatrix Wave PLUS U@home R-167 – Smartphone/tablet apps l 43
Installation selection
U@home module replacement/change of password
From the U@home app you can only manage one U@home
module at the time. This means that you will need to change
the active installation if you would like to access a different one.
You can select the active U@home module by pressing on
“Select installation” from “System Settings”. The active
If you replace your U@home module, this will be recognized
by the app when running in local mode. You will be requested
to reset the app and enter the device credentials again.
If you change your device password, you will also need to
reset your device configuration by removing the old
installation from the app and adding a new one with the
correct credentials.
U@home module is indicated with a green tick. In order to
select a new one, simply press on the U@home module/
installation name.
Note that the “Select Installation” button is only displayed if
there are more than one U@home module added to the app.
Please note that you need to be connected locally to do this.
You can find more information about how to set up your app
in the section “Configuration of the apps”.
Remove U@home modules from the app
You may need to remove devices that you have added to the
app (U@home module replacement, house sold, etc).
This can be done from the installation list by pressing on the
red cross to the right of the U@home module that you would
like to remove. After this a confirmation message will be
displayed.
