26
27
UPPAbaby MESA Instruction Book
UPPAbaby MESA Instruction Book
1
2
3
CARRIER INS
TALL
ATION WITH VEHICLE SE
AT BEL
T
STEP 1:
Place the carrier rear-facing on the vehicle seat.
STEP 2:
Make sure the vehicle is parked on level ground and the red line
on the carrier is level to the vehicle floor.
Lap/Shoulder Belt
Lap Only Belt
1
2
LEVELING THE CARRIER
DETERMINING BEST INSTALLATION METHOD
NOTE:
For a more stable
installation, a pool noodle
or rolled towel may be used.
If your vehicle does not have the LATCH System in your preferred seating
position, the car seat must be secured to the vehicle using a vehicle seat
belt. The car seat with the base or without the base can be secured using
vehicle seat belts. There are two methods of carrier only installation:
LAP/SHOULDER STANDARD ROUTING METHOD:
Installation with
both the lap and shoulder belt. (proceed to pg. 27)
LAP ONLY METHOD:
No shoulder belt is used. This method applies
to vehicle with no shoulder belt and aircraft. (proceed to pg. 29)
LAP/SHOULDER BELT STANDARD ROUTING METHOD
STEP 1:
Route the lap portion of
the seat belt through both lap belt
guides on the carrier, and buckle
the seat belt.
STEP 2:
Lock vehicle seat belt.
NOTE:
See vehicle owner's
instruction book for more
information on locking your seat
belt for child restraint installations.
WARNING!
Vehicle seat belt must
lock; otherwise a locking
clip must be used. See pg.
28 for instructions.
STEP 3:
Push the carrier into the
vehicle seat bight (crease of the
seat) while pulling on the shoulder
portion of the seat belt closest to
the buckle.
NOTE:
Check that the carrier is still
properly leveled.
CARRIER INS
TALL
ATION WITH VEHICLE SE
AT BEL
T
0225_MESA_INS_V4.indd 26-27
3/19/15 11:07 AM
Summary of Contents for mesa
Page 1: ...From 4 35 lbs ...