Page 10
TL50 Service & Parts
Transportation
T
RANSPORTATION
C A U T I O N
The TL50 is not designed to be forklifted, and does not have provision on the Chassis to allow this
method of lifting. Ui recommends the procedure below for handling the machine.
W A R N I N G
!
!
See specifications at rear of manual for the weight of the work platform and be certain that lifting
apparatus is of adequate capacity to lift the platform.
B
Y
C
RANE
The TL50 may be lifted by an overhead hoist/crane in the following manner :
Four lifting straps capable of safely supporting the total weight of the TL50 (2000kg) and being 2.4m long
for the axle straps and 3.4m long for the tow hitch straps and required. The strap length is important to
ensure the correct lifting angle is achieved (see diagram below)
The four lifting straps should be positioned as shown, care should be taken to ensure that they do not inter-
fere with any other parts of the TL50 and that they are secure before lifting.
B
Y
R
OAD
It is important that before commencing transport to ensure the vehicle used is capable of towing 2000kg.
The TL50 is a road approved vehicle and therefore may be transported behind a motor vehicle of suitable
towing capacity. It is recommended that the vehicle used should have a tow bar where the top of the ball is
at a height of between 1.42 ft (435 mm) and 1.64 ft (500 mm) above surface level. These dimensions are
important for the following reasons;
1. The bottom of the Platform may be in danger of hitting the surface while driving if the tow hitch is above
the upper limit.
2. The towing vehicle will support too much weight if the Towhitch is too low.
2.4m Lifting Strap
3.4m Lifting Strap
2 required
2 required
Summary of Contents for 503502-000
