Figure 8.9
2. To raise the platform, press and hold the
Platform Lift/Lower switch
up (see Figure
8.9).
NOTE
If the indicator light
is not lit, the platform will
not rise because: the chassis is not level, the
stabilisers (if present) are not properly set.
Correct the problem then continue.
3. To lower the platform, press and hold the
Platform Lift/Lower
switch
down (see
Figure 8.9).
■
Operating From The Platform Control
Box
Be fore you be gin to op er ate the
RT
from the plat -
form con trol box, a qual i fied op er a tor must per form
the Daily In
spec
tion and Main
te
nance as de
-
scribed in chap ter , of this manual
➜
Starting a gasoline, LP-only, or
dual-fuel engine
To start a gas o line, LP-only, or dual-fuel (LP & gas -
o line) en gine from the plat form con trol box do the
fol low ing:
Figure 8.10
1. Set the
Battery
switch
to on (see Figure
8.10).
Figure 8.11
2. Set the
Emergency Stop
switch
to on
(up) (see Figure 8.11).
3. Set the
Ground/Platform Selector
switch
to platform (up) (see Figure 8.11).
Figure 8.12
4.
For LP operation:
Completely open the valve
(see Figure
8.12) on top of the LP tank (unscrew
counterclockwise until it stops).
page 8 - 4
Rev A
SR3370 & SR2770 – 13184A
8. Operation
