Troubleshooting
Installation Manual
Page 48
560-0405-00 Rev –
December 14, 2001
© 2001 by UPS Aviation Technologies Inc.
9.2.3.3
Startup Page
When the transponder is turned on, the following page is displayed for a moment (during
boot up), then the display changes to the ‘AT7000 Self Test Running’ display.
The start up display is used to display the unit model number and main application soft-
ware version.
9.2.3.4
Self Test Running Page
The AT7000 Self Test page is displayed for three seconds every time ‘Self Test’ mode is
initiated.
9.2.3.5
Self Test Status Pages
The ‘Self Test Status’ page displays the number of currently active fault types.
9.2.3.6
Flight Legs Fault Status Page
The ‘Flight Legs Fault Status’ page displays the number fault types for the leg defined as
current leg – 0 to 9. '0' being the current leg and '9' being nine legs prior to the current.
In the event an EEPROM log failure occurs, LOG FAILURE appears on the second line.
The log failure only pertains to the leg attempting to be viewed.
9.2.3.7
Transponder Fail Status
The Transponder Fail Status page is used to display the failure status of the transponder
when the transponder fail LED is turned on.
Trnspndr Failure
1)
ICAO Address
2)
Transmitter
3)
Top Rcvr
UPS AVIATION
TECHNOLOGIES
AT7000 Mode S
SW Ver: 1.XX
AT7000 Self Test
Running
Self Test Result
0 Faults
Press TEST to
View Legs Info
