![background image](http://html.mh-extra.com/html/upswung/sentry-swing/sentry-swing_installation-and-maintenance-manual_1061367023.webp)
Installation and Programming of Receiver
and Transmitters
Installing the Receiver
1) Locate the 5 Silver Pins on your
MASTER
Estate Swing board, located above the
battery.
2) Locate the
white
connector on the receiver.
3) Push the
white
connector from the receiver on the 5 pins on your FAAC board with
the dip switches of the receiver board facing away from the center of the Estate
Swing board.
Setting the Dip Switches
1) Set the dip switches 1-9 on the receiver by
switching them in the up or down position.
Record this dip switch combination
2)
Slide
off
the
battery
cover
of
the
transmitter
(located
at
the
bottom front cover)
3)
Set the dip switches in the transmitter to
the same settings as the dip switches on the
receiver.
4)
Repeat this for all of the transmitters.
Positioning the Antenna
Bend the antenna to go around the back of the
receiver board and down the left side of the
Estate Swing battery.
Dip switches are located
under
the battery lid.
Summary of Contents for Sentry Swing
Page 49: ......