![background image](http://html.mh-extra.com/html/upswung/sentry-swing/sentry-swing_installation-and-maintenance-manual_1061367007.webp)
.
IMPORTANT INSTALLATION NOTES:
To ensure safety and an efficiently operating automated system, make sure the
following conditions are observed.
The gate and post must be suitable for being automated. Check that the
structure is sufficiently strong and rigid, and its dimensions and weights
conform to those indicated on page 1.
Make sure the leaves move smoothly without any irregular friction during
entire travel.
Make sure the hinges are in good condition. Ball bearing hinges are ideal for
gates weighing over 200 lbs. or over 10’ in length.
Make sure the gate is plumb and level.
The fence post must be secured in the ground with concrete. This will
prevent alteration of alignments and leveling during installation and
during cycles.
1,2
Sentry Swing Operator
3
Photocells (not included)
4
Master control board
5
Slave control board
6
Push button opening device (not)
7
Receiver extension (not included)
8
12Vdc flashing lamp (not included)
9
Positive stop included.
10
AC transformer
Notes:
1) Do not extend operator connection
cables
2) When laying electrical cables, use
appropriate rigid and/or flexible tube
Do not run any wires in the same conduit as 110
AC power that may be in the area. This will cause
unwanted interference
The system display to the below
is a recommended standard
system. Other approved
accessories can be installed.
Photo sensors and a flashing light
indicating gate movement is
recommended for safety purposes
Summary of Contents for Sentry Swing
Page 49: ......