Installation and use manual models FAST 02 e FAST 03 rev 1.0.0 October 2013 Page 13 di 19
FOG FLOW DIRECTION
To ensure the right direction of the fog flow, it is recommended to insert a
screw driver of a diameter of the hole and without forcing to orient the
nozzle in correct direction of fog emission
This allows you to see clearly the direction and keep it in place while
tightening.
To screw and unscrew the nozzle you should use a pair of pliers in good
condition to avoid damaging the plating.
Do not overscrew the nozzle, it is sufficient that the teflon nozzle does not
move.
Do not direct the fog jet towards objects and walls less than 2 meters or to the
floor if it is installed at a height lower than 2.50 meters.
WARNING!
After the fog emission, and for a few minutes the nozzle is very hot
RISK OF BURNS IF TOUCHED
by hands
13
INSTALLATION, EXCHANGE AND CYLINDERS RESET
The cylinders for fog cannons Fast 02 and Fast 03 are guaranteed to work for 3
years from production date.
The expiry date is printed on the top of them.
After that date cylinders should be changed even if they are not used.
It is recommend returning the same to the dealer, who will take care of
disposal.
For Model Fast 03 1C, with one cylinder, the reporting of "reserve" occurs
when the machine has shooted at least 50% of the expected duration of the
cylinder calculated in seconds and not in quantity of fluid shooten.
For this reason it is recommended to use only new cylinders, and reset only
when you actually inserts a new cylinder. After removing the screws from the
door, take away the cylinders and reset the warning light for empty cylinder.
After this operation, insert the new cylinder until you hear the "click" of the
plastic support at its top that goes into the slot, then close the door of the
cylinder.
If the cylinder seemed "stuck" in the upper part
DO NOT
pull with
force, make a pressure with two fingers on top of the cylinder, such as
to lower it. Then try again to remove it.
If the cylinder does not enter, check if the cylinder plate of the motor remains
lifted. If so see paragraph 14
In case of an empty cylinder to be replaced, it is recommended that it be replaced with
the second cylinder still charge present in the machine, and a new cylinder will replace
this last one.
This in order to ensure a proper rotation of the cylinders and to avoid that a cylinder
can remain unused for a long time within the device.
When you close the door, the buzzler
will sound to confirm the tamper is
closed.
Attention: Before opening side doors ensure that the alarm control panel is in the "service" function, so
that the opening of the circuit "anti-sabotage or tamper" does not cause any alarm.
