Fig. 50.
Installing
bearing 304
Fig. 49.
Shafts mounting
1
2
Reassembly of the Gear Case Cover
To reassemble the gear shift mechanism:
- Place home the gear case cover with the split joint upwards (Fig.48);
- Set the return spring of the gear shift mechanism by driving the spring ends behind the stop;
- Set the quadrant shaft with its short end into the hole in the right hand cover.
- Put intermediate bushing, and locking ring onto the shaft. Set shims between the quadrant and
the bushing to provide required clearance. The clearance should be 0.1
-
0.4 mm.
- Fasten the ratchet bracket with bolts and lock them with wires.
- Screw in the return spring stop, the cylindrical end of the stop should locate between spring
ends.
- Screw in the adjusting screws.
- Set the spring onto the reverse gear quadrant.
- Insert the quadrant shaft into the gear case cover hole.
- Set the reverse gear shift lever onto the shaft splines and fix it.
Fig. 48.
Gear case cover.
To reinstall the gearbox shafts:
- Set the clutch shaft and main shaft into the cover bringing their teeth in mesh (Fig. 49);
- Put bearing 304 onto the main shaft (Fig. 50)
- Mount the shift forks, bring the fork lugs into the coupling slots, set the forks in neutral
position and insert their pins onto the quadrant slots (Fig. 51, Pos.1);
- Mount the fork shaft (Fig.51, Pos. 2).
Fig. 51.
Setting the shift forks.
60
Summary of Contents for 750cc Series
Page 1: ...Repair Manual 750cc All Models www imz ural com ...
Page 2: ......
Page 71: ...1 2 3 4 5 6 7 8 Fig 66 Final drive 71 ...
Page 98: ...Fig 11 iring Diagram 9 W 98 ...
