urban ambiance UHP9220, Installation Manual

8.

Installing the Light Kit 

and Glass Shade

CAUTION - To reduce the risk of electrical 

shock, disconnect the electrical supply circuit 

to the fan before installing the light kit.

Blue

White

Molded

Adaptor Plugs

Black

White

Mounting

Screw (3)

Light Kit

Assembly

LED

Module

Glass

Light Kit

Assembly

Raised

Dimples

Flat Area

Figure 14

Figure 15

Mounting

Screw (3)

Light Kit

Assembly

Light Kit

Adapter

Figure 13

PERIODICALLY CHECK THE SHADE IS SEATED 

FULLY CLOCKWISE IN THE LIGHT KIT PAN 

ASSEMBLY

1.  Loosen but do not remove two of three 

mounting screws from the fan motor 

assembly; Remove one mounting screw.

(Figure 13)

2.  Push the light kit pan up to the fan motor 

assembly so that the two loosened screw 

heads fit into the keyhole slots. Turn the 

light kit pan clockwise, tighten the screws. 

Re-install the screw that was removed in 

step 1 and tighten firmly.(Figure 13)

3.  Remove one screw from the light kit pan 

and loosen, but do not remove, the other 

two screws. Connect the wires from the 

light kit assembly to the wires from the fan 

motor assembly by connecting the molded 

adaptor plugs together. Carefully tuck 

all wires and splices into the switch cap. 

(Figure 14)

4.  Push the light kit assembly up so that 

the two loosened screw heads fit into the 

keyhole slots. Turn the light kit assembly 

clockwise, tighten the screws. Reinstall 

the screw that was removed in step 3 and 

tighten firmly. (Figure 15)

5.  Place the glass shade into the light kit 

pan, aligning the three flat areas on the 

top of the glass shade with the three raised 

dimples in the light kit pan. Turn the glass 

shade clockwise until it stops. (Figure 15)

THE GLASS IS FRAGILE, USE CARE WHEN 

INSTALLING THE LIGHT KIT AND THE GLASS 

SHADE.