Page 6
DMS-IN Owner’s Manual
Wiring the DMS-IN
In order for the DMS-IN to provide the best possible experience, it must be first wired correctly then programmed by a Total Control Certified
Installer. Follow these steps to prepare the DMS–IN for programming:
1. Power the DMS-IN with the supplied 5V DC adapter
OR
PoE using the LAN port (see below)
2. Connect and Ethernet cable from the LAN 10/100 port to an MFS-8/MFSPOE-8
●
The 5V DC adapter is not required when using PoE
3. Connect a source via Analog or Digital that is to be a part of the DMS Audio Stream
Additional set up is required via the URC Accelerator software. Contact a Certified Total Control Installer to properly configure the DMS-IN to a
new or existing system.
OR
Only one source can be used at a time, further audio
adjustments can be made from within Accelerator.