2
Device Layout
Button Layout
Sync button:
Used to include and exclude devices from the
Z-Wave network (see page 7 for details)
WPS button:
Enables Wi-Fi Protected Setup Mode (should only be
used by qualified integrator, or as directed by URC Technical Support)
Reset button:
For use only when directed by technical support
Installation
Device Connections
Use the supplied network (Ethernet) cable to connect the TRF-ZW2’s
Ethernet port to your local area network (router or network switch)
Connect the supplied DC adapter to the TRF-ZW2 and plug the adapter into
an AC receptacle
Upon power-up the TRF-ZW2 checks for an available firmware upgrade. If an
upgrade is available it is installed automatically. The update process takes 15
minutes or less and is indicated by the Power LED flashing. When the Power
LED assumes its normal state (solid green), the TRF-ZW2 is ready for use.
Sync button
WPS button
Reset button
1
1
2
6
Summary of Contents for TRF-ZW2
Page 1: ...i TRF ZW2 Z Wave Gateway Owner s Manual ...
Page 17: ...14 Notes ...