PV Module Installation Instructions
9
/
12
Installation Method
There are two ways to install the modules: Figure A shows a lock block clamp
type and Figure B shows a back bolt fixed type.
1)
stainless steel nut
2)
stainless steel washers
3)
M8 stainless steel bolts
4)
spring washer
As shown in the example, the tightening torque (stainless steel bolts with M8) must
be 8-10N.m. Use the holes that already exist on the modules to secure the modules
and not allow further drilling (doing so will no longer provide warranty). Use a
suitable corrosion-resistant fastening material.
Precautions during installation
◇
When carrying the modules, two hands are required to grasp the modules and keep
a level of stability. It is forbidden to shake severely, carry the module by one
person, drag the module, pull the connecting lines of junction box and handle two
and more modules.
◇
Place the modules on a flat ground, place the cardboard in the bottom and the glass
surface is forbidden to directly touch the ground.
◇
When the module is placed on the ground, it is forbidden to stack debris, step on,
sit down and have other actions that may cause deformation for the module.
◇
Do not step on the module during installation. Do not drag the module on the
bracket.
◇
Other incorrect transportation or installation those may damage the modules.
Example A: Fixture Fixed
Example B: Bolt Fixed
