7
Function Table
*Below functions and features subject to change without notice.
Function
Description
1. Copy
Data or whole media duplication only.
2. Compare
Bit-for-bit comparison between the source and target flash
medias.
3. Copy&Compare
First copies, then compares the target to the source once
duplication is completed.
4. Media Check
4.1 H2+Format
Precheck t
he 2.0 / 3.0 signal of the flash’s first, then do H2 and
Format.
4.2 H2+Format
Checks the flash’s quality by reading and writing H2 files
, then
fo
rmat the flash’s.
4.3 H2
Checks the flash’s quality by reading and writing H2 files.
4.4 H5+Format
Precheck t
he 2.0 / 3.0 signal of the flash’s first, then do H5.
4.5 H5+Format
Checks the flash’s quality by reading and writing H
5 files.
4.6 Setup Range %
Sets the flash’s checking range percentage
from 1% to 100%
4.7 Setup Range MB
Sets the flash’s checking range in MB
from 1MB to 9000MB.
4.8 Set ErrorLimit
Sets the error tolerance range when checking the flash.
4.9 Minimum Read Speed
Sets the minimum read speed from 0~260MB/sec.
4.10 Minimum Write Speed
Sets the minimum write speed from 0~260MB/sec.
4.11 Low Speed Tolerance Time
Sets the tolerance time when flash does not reach the minimum
speed from 10~99 seconds. The default value is 30 seconds.
4.12 Set Capacity Limit
Set Upper Limit
Set Lower Limit
Clear Limit
