50-001-666 DOC.CLAVIER SAIL.KPAD HF FDI FR/GB/NL/DE.B
Tamper
The RF keypad uses an accelerometer so it is able to send a RF frame in case of vandalism.
With the following sequence, the user setup the relay to be activated in case of tamper. This means one relay has to be
dedicated to this feature.
This sequence has to be setup when the keypad is fixed in its final position in order to determine its reference point.
Combination between the keypad and the Easy Door Receiver
The Wireless K-PAD is considered as a remote control for the receiver. To add the keypad in the receiver:
1-
Move the dipswitch 1 of the receiver onto ON to enter in programing mode. The receiver will beep twice.
2-
Type the master code on the keypad. The receiver will beep once then you successfully add the keypad.
3-
Turn OFF the dipswitch 1
NOTE: the receiver can manage up to 10 master codes.
By turning the dipswitch 6 of the receiver into ON, you can choose which relays will be activated, depending on the access
code programing in the keypad. This function is used on a site where there is 1 keypad for 2 receivers:
•
Dipswitch 6 OFF (by default): the receiver will manage the access code set for the relay 1 & 2
•
Dipswitch 6 ON: the receiver will manage the access code set for the relay 3 & 4
INFORMATION ON UNION HARMONISATION LEGISLATION
FDI MATELEC, as a manufacturer, declares under its sole responsibility that the RF K-PAD ref GB-060-318 complies with the
relevant Union harmonisation legislation :
RED 2014/53/EU – CEM 2014/30/EU – ROHS 2011/65/EU
This declaration is fully available on request at sales@fdimatelec.com or on our web site www.fdimatelec.com under this
product part number.
PRODUCT END OF LIFE MANAGEMENT
Do not throw this product away with household waste. Please use your local recycling collection points to make sure this
product is properly recycled.
38 00 #
00 Not active
01 Relay 1
xx Relay x
Validation
Slot
37 00 #
00 not active
01 active
Validation
Slot
