85
DS1375-020E
Once the gateway item no. has been selected, the gateway configuration page will be shown to enter the following
parameters:
—
MAC Address:
enter the MAC address of the gateway to be set (written on the rear side of the product), only
numbers and characters (small), without any separators. Once this parameter has been entered, it is possible
to save and wait for the automatic configuration of the device.
—
Number of Channels:
specify the number of analogue/ISD/GSM lines that will be connected to the gateway
that is being set (and not depending on the total number of lines that the gateway can potentially manage).
The same number of Urmet GW licences should be available on the iPerTAlk system for each one of these
channels.
—
Note:
enter a description that defines the intended use.
—
Registration parameters (User, Password):
parameters for the authentication on the SIP protocol level,
which must correspond to those configured in the gateway that is being set.
In the automatic installation mode, such parameters are autonomously managed by iPerTAlk, therefore it is
necessary to edit them only if you want to customise them and after that they have been updated on the relevant
gateway.
In some special situations, it may be necessary to customise all the parameters of the Advanced Configuration
section or part of them.
Below are the following parameters:
—
Codec:
audio codec that will be used to manage the audio stream (pcma by default). Usually it is changed
when it is necessary to limit the bandwidth or to increase the audio stream resolution; this value has to be
configured as stated in the configuration parameters of the gateway that is being set.
—
Presentation Calling Number:
parameter that is not useful in case of analogue and GSM lines; in case of
ISDN lines it may be possible that there are several available lines with different numbers but the Operator
allows setting a specific number for outbound calls (multi-number ISDN with Automatic Search).
—
DTMF:
sending mode of the selecting digits during the calling phase, for example to dial the choices of an
automatic answering machine.
—
PROBE:
It allows sending a device reachability verification package.
—
Manipulation Calling Number:
it allows editing the calling number only for incoming calls.
—
Manipulation Called Number:
it allows editing the called number only for incoming calls.
Line gateways also allow editing calling numbers The same number can be shown in a different way when entering
the system. To uniform and hence manage the calls according to the routing rules and/or find the number in the
directory, it is therefore possible to modify the numbers so that they are edited. To make such modifications,
access the advanced parameters of the line gateways and enter the editing rules.
Summary of Contents for iPerTAlk 1375
Page 98: ...98 DS1375 020E...
Page 99: ...99 DS1375 020E...
