88
DS1375-020E
12.9.3 LINE TRUNKS
This section allows configuring line trunks in order to specify the port of the line gateway to be used for incoming
calls.
If a line gateway has been already configured, a trunk including all the gateway ports will be automatically created.
To create a new trunk, click on the button
and enter the relevant parameters.
—
Name:
indicate the name for the new trunk.
—
Devices:
it shows the list of the ports of the line gateways configured in the system that can be associated with
the trunk, since they have not been associated yet with any trunk. To associate ports with the trunk, select one
port at a time and use the button > to perform the association. Press the button >> to directly associate all the
ports. Press instead buttons < and << to disassociate ports from the trunk. Any ports already associated with
other trunks is not be listed since each port can be associated to one trunk only.
—
Call Direction Filter:
allows limiting the use of the trunk to inbound or outbound calls only. If no filter is
configured, the trunk can be used for calls in both directions.
12.9.4 SYSTEM SETTING
12.9.4.1 SYSTEM
The parameters that can be set in this section are as follows:
— System prefix: fixed 90.
—
Extensions root:
fixed 100.
— District prefix: area code of the installation telephone network, e.g. 011 for Turin, 06 for Rome.
—
No answer timeout (seconds):
waiting time for an inbound/outbound call to be considered as not answered.
—
Callback on Busy Timeout:
function not enabled.
—
Doorphone conversation timeout :
maximum duration of door phone calls.
Summary of Contents for iPerTAlk 1375
Page 98: ...98 DS1375 020E...
Page 99: ...99 DS1375 020E...
