79
DS1375-020E
12.9.1 EXTENSIONS
Terminal acquisition:
—
Enabled:
it allows the self-configuration of supported Urmet devices. When they are connected to the network,
an extension number is automatically assigned and they are entered in the system.
—
Disabled:
it allows the automatic detection of supported Urmet devices. When they are connected to the
network, they are detected, but their acquisition has to be confirmed by the administrator.
Key allows deletion.
Icon
indicates that the terminal is registered and can handle calls,
indicates that it is configured is out of
service,
indicates a multi-line terminal with at least one of the extensions not registered.
Key
allows adding a terminal choosing it among the supported models.
12.9.1.1 GATEWAY CONFIGURATION
The gateway configuration procedure (for all Urmet models) allows a use limited according to the licences (line or
extensions) owned.
For example, a PABX purchased with bundle 1375/10 includes a licence that enables the use of 1 Line and 3
Extensions.
Therefore, it will be possible to add a gateway (e.g. 1375/854, that features 4 FXS ports and hence 4 analogue
extensions), by setting the number of channels (derived ones or extensions in this case) that you want to use, up
to the maximum permitted by the licence installed in the system (3 in this case).
The gateway adding screen features the following fields:
—
Name:
enter the name of the device, which will be displayed in the extensions summary table.
—
MAC Address:
enter the MAC address of the gateway to be set (written on the rear side of the product), only
numbers and characters (small) without separators. Once this parameter has been entered, it is possible to
save and wait for the automatic configuration of the device.
—
Distinctive Ring:
it enables or disables the distinctive ring for calls coming from extensions, lines or outdoor
stations (this function is not available for devices 1375/854 and 1375/859).
—
Number of channels:
it allows you to customize the number of extensions or the number of lines that the
device can manage (the minimum is 1, while the maximum depends on the physical limit of the device itself).
The number of channels always depends on the number of licenses available for that extension or line type.
—
Remarks:
enter a description that defines the intended use.
Summary of Contents for iPerTAlk 1375
Page 98: ...98 DS1375 020E...
Page 99: ...99 DS1375 020E...
