Urrea EA1005, User'S Manual And Warrantly

13

E N G L I S H •

User's Manual

When making masonry cuts, always cut with a 
cutting guide. The cut direction is very impor-
tant on this kind of operation. The tool must 
work in the opposite side to the rotation direc-
tion of the cutting disc.

 CAUTION: it will generate sparks when you 

grinded on metal. Be careful that it doesn’t 
make contact with combustible materials

MAINTENANCE

 WARNING: It’s recommended that all repa-

rations been made by an authorized service 
center. 

GENERAL MAINTENANCE

Before each use inspect the tool, the switch and 
the wire to check any damage. Verify that don’t 
have damaged, missing or worn parts. Check 
if there are lost screws, misalignment or loose 
moving parts or any other condition that may 
affect the operation.
If an abnormal vibration or noise occurs, imme-
diately turn off the machine and solve this issue 
before to try use again.

CARBON BRUSHES

The carbon brushes and the collets must be 
examined frequently. A good contact result the 
tool to be strong. When the spark around the 
collector becomes largest the carbon brushes 
should be changed.

CLEANING

 WARNING: before to clean or realize any kind 

of maintenance, the tool must be unplugged of 
the power source. The most effective cleaning 
method could be flow the tool with dry com-
pressed air. Always use goggles when perform 
this activity. Keep the handle clean, dry and oil 
free. Use only a gently soap and a wet wiper 
to clean the tool. Many cleaning products has 
chemical which can seriously damage the plastic 
and other isolated parts.
The ventilation slots must be kept clean. Don’t 
try clean it introducing sharp objects trough 
ventilation slots. 

 CAUTION: don’t use chemical agents as pe-

troleum, solvents or similar products to clean 
the tool. 

 WARNING: use only accessories that are 

recommended by the manufacturer for your 
model. Accessories that may be suitable for one 
tool may become hazardous when used with 
another tool.

 WARNING: maintain tools with care. Keep 

cutting tools sharp and clean.
Properly maintained tools, with sharp cutting 
edges, are less likely to bind and are easier to 
control.

 WARNING: check extension cords before 

each use. If damaged, replace immediately. Nev-
er use tool with a damaged cord.

TROUBLESHOOTING

MOTOR DOES NOT START
Tools is not plugged in: check that all cords are 
plugged in.
Fuse: check the time-delayed fuse or circuit 
breaker.

TOOL VIBRATES OR SHAKES
Damaged disc: replace disc
Loose disc: tighten arbor bolt.
If the machine presents other problems contact 
your closest service center for maintenance.