Urrea FUMU16, User Manual

10

SPECIFIC SAFETY RULES FOR GAS 
SPRAYER

1. Before using sprayer with chemicals, fill spray-
er with fresh water to assure that you have it 
properly assembled; pressurize and practice 
spraying. Also, check for any leaks at this time. 
When thoroughly familiar with the sprayer op-
eration, follow normal operating procedures.
2. Ensure all pressure in the sprayer is relieved by 
locking the shut-off valve in the open position.
3. Avoid contact with chemicals.
4. Always wear rubber gloves, safety goggles 
and appropriate protective clothing.
5. Work in a well ventilated area.
6. Individuals should be trained in the proper use 
of this sprayer, chemical handling procedures, 
and first aid/emergency care. Where training is 
not available, individuals should study and fol-
low the procedures detailed in this manual.

 WARNING: chemicals can be harmful to in-

dividuals and the environment if improperly 
used. In addition, some chemicals are caustic, 
corrosive or poisonous and should be avoided. 
Read warnings and chemical manufacturers’ 
instructions. Solo high density polyethylene 
sprayers are fitted with chemical resistant seals 
which are compatible to a wide variety of ag-
ricultural and household chemicals; however, 
care should be exercised to ensure that sprayer 
components are clean, functioning properly, 
and in a good state of repair before and dur-
ing use. If in doubt about a particular chemical, 
check with the manufacturer. If you suspect or 
observe indications that the material may be 
unsafe in a Solo sprayer...STOP. DO NOT USE 
OR APPLY CHEMICAL. ALWAYS WEAR RUBBER 
GLOVES, GOGGLES, AND APPROPRIATE PROTEC-
TIVE CLOTHING!
• Read and follow operating instructions.
• Do not fill with, use, or spray flammable mate-
rials, including Diesel Fuel.
• Do not modify sprayer.
• Never spray in the direction of humans, ani-
mals or property which might be injured or 
damaged by spray formula.
• Do not use disinfectants, solvents or impreg-
nating agents unless first tested to ensure they 
are not harmful to the environment or sprayer.
• Do not use liquids with a temperature above 
110°F (43°C).
• Wear appropriate protective clothing to pre-
vent contact with chemical agents.
• Rinse and clean sprayer thoroughly after us-
ing. Disposal of contaminated rinse should be in 

accordance with applicable ordinances. Observe 
the precautionary instructions of the chemical 
manufacturer.
• Do not use any acid (including citrus) or caustic 
chemicals. 
• Remember that a sprayer with liquid is a sig-
nificant amount of weight (8 lbs. per gallon). Do 
not climb when wearing the sprayer. Use cau-
tion when bending, leaning or walking. Bend at 
the knees rather than the waist.
• During sprayer operation, the pressure cylin-
der contains compressed air and liquid. Com-
pressed air and liquid under pressure are inher-
ently dangerous. 

FEATURES

KNOW YOUR TOOL

Before attempting to use this product, become 
familiar with all of its operating features and 
safety requirements.

1. Tank.
2. Ignition plug.
3. Recoil starter.
4. Knapsack strap.
5. Throlle lever.
6. Stop button.
7. Fuel tank (FUMU16).
8. Nozzle.
9. Nozzle lance.
10. Drain.

7

8

9

10

1

3

2

4

5