• Before starting working, set the die head to
threading state, turn ON the switch and check
on correct supplying of threading oil fluid from
the die head (Oil fluid is applied to the chaser),
to prevent incorrect threading of the pipe,
troubles of the machine, accidents and injuries.
9. Be sure to observe the threading start posi-
tion.
• In threading, start the shuttle bench from
the right side of the red line put on the pipe
receive on the front side (in viewing from
the machine working position). If the shuttle
bench is not started from the correct position,
the die head bits the main unit during thread-
ing, causing troubles of the machine, accidents
and injuries.
10. Use the pipe support in threading long size
pipes.
• In threading long size pipes, use the pipe
support to prevent vibration due to warping
during rotating and instability of the machine
due to material weight.
• If the pipe support is not provided, threading
can not be made correctly or troubles of the
machine, accidents and injuries occur.
11. Surely fit the accessories according to the
Instruction Manual.
• Insufficient fitting causes dropping and fall-
ing of the units, accidents and injuries.
CHAMFERING WORK
Since the reamer blade tip is acute, do not
touch it directly with hands, to prevent injuries.
FLUID FOR THREADING
1. Use only the appropiate threading fluid.
2. Wear goggles. Touch to the eyes may cause
inflammation. For an emergency treatment,
wash your eyes with clean water for about 15
mins., and receive medical check.
3. Wear protection gloves. Touching to the skin
may cause inflammation. If do, carefully wash
the touched part with water and soap.
4. Take care to not suck oil mist and steam.
Sucking oil mist and steam may cuase a sick
feeling. In case you do, go to a place with fresh
air, cover the body with a blanket etc., to keep
a good body temperature and rest, receive
medical treatment immediately.
5. Do not thin the oil fluid or mix it with
threading oil fluids of other companies.
6. When water is mixed during the use of
threading oil fluid and color is changed to
milky white or the oil fluis is excessively de-
teriorated and the surface finishing is worse,
change these fluids immediately.
7. Do not drink the oil. Drinking it may cause
loose bowels and vomiting. In case someone
else drink, do not let the person vomit forcibly
and immediately receive medical treatment.
8. Do not put the oil at places easily available
for children.
9. Storing method:
Close the lid after using, this will prevent the
entry of dust, water and other substances.
Since the oil is chemical, store in a dark place,
and make sure it will not be exposed to direct
sun light.
10. Treating waste oil and waste cases. Treating
methis are stipulated by laws and regulations.
Thread according to the laws and regulations
on waste disposal and cleaning. When uncer-
tain, consult with your sales agent or our com-
pany sales office for treatment.
11. Notices in drums (200 L). Do not apply pres-
sure to vacant drums, to prevent bursting. Do
not perform welding, heating, drilling and
cutting to the drums, to prevent bursting and
firing due to residues.
FEATURES
KNOW YOUR TOOL
1. CUTTER.
2. REAMER.
3. DRAIN PLUG.
4. CARRIAGE HANDLE.
5. FOOT SWITCH.
6. REAR CHUCK.
7. HEAD WHEEL.
2
3
4
5
1
6
7
14
TRM300 manual.indd 14
09/06/15 15:10
