Flipo F95
Note: Because VTX1 supports 48 channels, users can select any of
the 48 channels by pressing keys. But at present, Betaflight's OSD
parametric function only supports 40 channels, so users can only
configure 40 channels on the OSD screen.
If the user chooses one of the eight channels that OSD parameters
do not support and enters OSD parameters, the system will
automatically change the user's original channel to A1 channel on our
frequency table (5865 MHz), that is, the user can configure only 40
channels with OSD parameters.
After configuring the grouping and channel, you need to enter the
SET item and select YSE to take effect (Figure 6).
Figure 6
Grouping and channel configuration validation
③Output power configuration
As in the previous section, the POWER item can be entered by
remote control selection, and the required transmission power can be
selected (Fig. 7). VTX1 currently supports only 25 mW power options,
while the POWER menu with OSD parameters has four options: 25 mW,
200 mW, 500 mW and 800 mW. Therefore, users need to pay attention
to the choice of 200 mW, 500 mW, 800 mW options will be VTX1 set to
25 mW transmission power.
Note: Unlike configuring BAND and CHAN, POWER settings do not
need to enter the SET entry confirmation, and take effect immediately.
