US Blaster Turntable USB 7363 User Guide
7
5. Using the turntable
If you have carried out all the actions described so far, the appliance is now ready to use.
You can connect the turntable to an amplifier or audio mixing desk using the pre-fitted cinch cables.
Do not forget to attach the extra mass cable to the amplifier or mixing desk. If you don't do this you run
the risk of hearing extra buzz or noise on the loudspeakers.
Using the turntable is relatively simple.
Select the correct rpm using the rpm switch (14/15). Use – if necessary – the separate adapter (1) for
singles.
Position the pick-up arm above the starting groove of the LP record or single and press the start button
(5). Then lower the arm on to the record using the operating lever (8).
If you have listened to (part of) a record you can follow the above process in the reverse order;
Lift the arm off the record with the operating lever (8) and then press the start/stop button (5). After you
have placed the arm back in its intended holder, you can take the record off the revolving deck.
6. Replacing the MD element
Your turntable has a universal element holder. You can replace the supplied element with one from
another manufacturer, as desired.
the fastening for the element – also for other manufacturers
–
is completely standardised. The
fastening method is shown in the diagram below. It is important, when assembling, that the connecting
cables are properly connected.
White:+ Left channel
Blue:
- Left channel
Red:
+ Right channel
Green: - Right channel
If you do not connect the connections correctly to the element you run the risk that the audio
information from an LP record or single not, or only partially, being audible.
