18
www.uscutter.com
425.481.3555
Connecting The Cutter To A Computer
Attach the power cord to the cutter and then
plug in the unit and turn on the power.
If using the Serial Cable to connect
your cutter to a computer:
If using the USB Cable to connect
your cutter to a computer:
If you are using a Serial Cable to connect your cutter to a computer then
no further setup is necessary. Simply connect one end of the cable to
the cutter and the other end to a computer and setup is complete. If
you have more than one serial connection on your computer or you are
experiencing communication issues between your cutter and computer
then you may wish to verify that the correct COM port is being used in
your software setup, but for most users the COM port will be COM1.
Most current versions of Windows and the current VinylMaster release
already have drivers pre-loaded. If, howver you find you still need to install
drivers go to
www.uscuttersupport.com/mh-support-page
and select the
driver that supports your older Windows version.
INSTALLING VINYL MASTER SOFTWARE
Your MH Vinyl Cutter comes bundled with
VinylMaster Cut
software, an easy to use software with the tools to
help you take your projects from concept to a ready to cut computer image file.
You can download and install the
VinylMaster Cut
software at
www.uscutter.com/download
, and you will need
the key code (sometimes referred to as a PSN) packaged with this cutter to activate the software.
Training for VinylMaster is all done via short videos accessed through the software.