28
www.uscutter.com
425.481.3555
Care and Maintenance
Some Cutter Parts will require periodic replacement:
• The blades packaged with your MH cutter will dull with time and usage. In general, the
blades with the sharpest points like the 60 degree blade will dull fastest in much the same
way that a very sharp pencil point will wear down quickly. To keep your cuts clean and to
avoid wasting media and vinyl, it is recommended you replace blades after 6 months of use
or whenever cutting becomes jagged or inconsistent.
• Cutting Strips will also require periodic replacement: The cutting strip is the protective strip
that is found right below the carriage arm that prevents damage to the cutting blade. Over
time it will develop small cuts and abrasions – and it may happen quickly if you are creating
decals or other projects where the blade will cut through the liner of the media.
• Blade holders will gather small bits of material in them: Over time, this accumulated debris
can prevent the blade from moving smoothly over the cut media. Occasionally removing the
blade holder cap and cleaning out the debris will help prolong the life of the bladeholder, but
they do wear out with time.
Replacement blades, blade holders and cutting strips for MH Cutters can be found at: http://
www.uscutter.com/Cutter-Blades-Bladeholders
Storage of Your Cutter
• During periods when the cutter is not in use, please unplug the cutter from the power source.
• Covering the cutter with a plastic sheet or other lint free cloth or water resistant material to
prevent accumulation of dust is also recommended.
• Always store your cutter in a cool, dry location