© 1999 US Electronics Components Corp.
All rights reserved
Part Number USE17667, version 1.1
9904
User’s Guide for the
UZ Series
2-in-1 Cable TV Remote Control
featuring Memory Lock
™
If you have a TV with a remote
control, we recommend that you
plug its power cord directly into a
wall outlet if available (your cable
installer may select an alternate
setup).
Make sure to set your TV to
channel 2, 3, or 4 as directed by
your cable company.
Locate the
[TV POWER], [CABLE
POWER], [SETUP],
and number
buttons on the illustration below.
You’ll use these to setup your
remote control.
Press the
[SETUP]
button, then the
[CABLE POWER]
button.
Enter the three-digit code for your cable box from the
chart below.
Press the
[CABLE POWER]
button.
Press the
[CABLE POWER]
button again to test the remote.
If your cable box turns on and off, proceed to the steps
below to setup the remote for your TV. If your cable box
doesn’t turn on and off, verify that you are using the right
code for your cable box (see the chart below), and perform
steps 1 through 3 again.
BEFORE YOU BEGIN
1
INSTALL BATTERIES
2
KNOW YOUR REMOTE
3
IMPORTANT NOTE
!
Weak batteries may disrupt
normal operation of the remote
We recommend that you use only AAA alkaline batteries.
SETTING UP YOUR REMOTE
4
FOR YOUR CABLE CONVERTER
SETTING UP YOUR REMOTE
5
FOR YOUR TELEVISION
b
c
d
e
b
c
d
e
Make sure your TV is on. Press the
[SETUP]
button, then the
[TV POWER]
button.
Enter the three-digit code for your television from the
“television codes” chart on the back of this sheet .
At this point you have two options depending on whether
you want volume to be controlled through your cable box or
through your TV:
option 1:
If you want volume to be controlled through your
cable box, press
[CABLE POWER]
.
option 2:
If you want volume controlled through your TV,
press
[TV POWER]
.
Press the
[TV POWER]
button again to test the remote. If
your TV turns on and off, you’re all done. If your TV doesn’t
turn on and off, perform steps 1 through 3 again with the
next available code for your TV brand. If none of the codes
listed for your TV work, try the CodeScan
™
method (on the
back of this sheet).
GENERAL INSTRUMENT
®
DCT1000/CFT2200
000
PIONEER
®
BAV-1000
003
SCIENTIFIC-ATLANTA
®
8600X
001
SCIENTIFIC-ATLANTA
®
EXPLORER 2000
004
ZENITH
®
MM2500
002
Install two
AAA alkaline batteries
as shown here
Before you can program or operate the
remote control, you must install two AAA
Alkaline batteries.
Step 1
Remove the battery compartment cover on
the back of your remote control.
Step 2:
Check battery polarity carefully, and
install the batteries as shown in
the illustration below
Step 3:
Replace the battery compartment cover.
MEMORY L
OCK
™
featuring
