-3-
* Pellet size may effect the actual rate of fuel feed and burn times. Fuel feed rates may vary by as much as 20%.
Use PFI listed fuel for best results.
FUEL CONSIDERATIONS
Your pellet stove is designed to burn premium hardwood pellets that comply with Association of Pellet Fuel
Industries standards. (Minimum of 40 lbs density per cubic ft, 1/4” to 5/16” diameter, length no greater than 1.5”,
not less than 8,200 BTU/lb, moisture under 8% by weight, ash under 1% by weight, and salt under 300 parts per
million). Pellets that are soft, contain excessive amounts of loose sawdust, have been, or are wet, will result in
reduced performance.
Store your pellets in a dry place. DO NOT store the fuel within the installation clearances of the unit or within the
space required for refuelling and ash removal. Doing so could result in a house fire.
Do not over fire or use volatile fuels or combustibles, doing so may cause a personal and property damage
hazards.
SAFETY AND EPA COMPLIANCE
Your pellet stove has been approved for installation in the USA and Canada. It may also be installed in a
manufactured or mobile home. Your stove conforms to ASTM E 1509-12, and Certified to ULC S627-00, and(UM)
84-HUD.
Electrical Specifications
Electrical Rating
120 Volts AC, 60 HZ, 3 Amps
Watts (operational)
125W
Watts (igniter running)
310W
Dimensions
Height
37.16” (944mm)
Width
20.81” (529mm)
Depth
22.25” (566mm)
Weight
162lbs
Specifications
WARNING: It is against federal regulations to operate this wood heater in a manner inconsistent with the
operating instructions in the owner’s manual.
Note: Register your product on line at www.usstove.com. See “Limited Warranty” section for specific warranty
information for your new purchase. Save your receipt with your records for any claims.
Heating Specifications
Fuel Burn Rate* (lowest setting)
1.4lbs per hr
Burn Time (lowest setting)
32 hrs
Hopper Capacity
46lbs
Flue Size
3“ or 4” (77mm to 102mm)
