3
Proper Installation
This water softening system must be properly installed and located in accordance with the
Installation Instructions before it is used or the warranty will be void.
Do not
install or store where it will be ex-
posed to temperatures below freezing or ex-
posed to any type of weather. Water freez-
ing in the system will break it. Do not attempt
to treat water over 100°F.
Do not
install in direct sunlight. Exces-
sive sun or heat may cause distortion or oth-
er damage to non-metallic parts.
Properly ground to conform with all govern-
ing codes and ordinances.
Use only
lead-free solder and flux
for all
sweat-solder connections, as required by
state and federal codes.
Maximum allowable inlet water pressure is
125 psi
. If daytime pressure is over 80
psi, night time pressure may exceed the
maximum. Use a pressure reducing valve
(PRV) to reduce the pressure.
Softener resins may degrade in the presence
of chlorine or chloramines. If the feed water
contains chlorine or chloramines, reduced
life of the resin could occur. In these condi-
tions, it is wise to consider purchasing a
whole house carbon filter system with a chlo-
rine reducing media. Contact US Water Sys-
tems for Chlorine and Chloramine removal
equipment.
WARNING:
Discard all unused parts and
packaging material after installation. Small
parts remaining after the installation could be
a choke hazard.
32° - 100° F
No Direct Sunlight
Conform to all
Governing Codes
125 Max. PSI
2 ppm Max. Chlorine &
Chloramine
Discard All
Unused Material
