27. Slowly place the bypass In Service position and let water flow into the mineral tank. Open the bypass in
small increments until it is fully open. When water flow stops,
slowly
open a cold water tap nearby and
let water run until air is purged from the unit. Preferably a garden spigot or bath tube. Then close tap
once the water runs clear and there is no air in the system. The bypass valve pointer should be pointing
toward “service” and the handle should be in line with the plumbing connections.
Electrical
28. Make all electrical connections according to codes. Plug the valve into an approved power source.
29. The valve position will be displayed on the control panel. If the unit is in the regeneration process the cycle
will be shown on the screen. When the system is in the service position it will display the time of day and
flash to the amount of gallons that are remaining before a regeneration of the tank in service is required.
