4
Installing the Filters & Connections
When handling filter cartridges be sure hands are clean and sanitized or wear surgical gloves.
1. Loosen and remove filter housings using wrench provided.
2.
Remove plastic wrapper from filter cartridges. Check the o-ring to insure it is lubricated. If not, use
NSF approved silicon grease. Install the o-ring into the filter housing. Install the filters into the correct
locations as indicated in Figure 1 on page 4. Insure the Carbon cartridges are installed with the rubber
gasket at the top.
3. Install and tighten the filter housings firmly by hand. Use the wrench provided to tighten an addition
1/4 to half turn. Do not over tighten.
10” 5 Micron Sediment Filter
10” GAC Carbon Filter
Inlet Connection
Drain Connection
