7
- The jump starter is placed on a stable surface, either on the ground or on the vehicle.
- First connect the red positive (+) clamp to the vehicle’s positive (+) terminal, and then connect the black negative (-) clamp
to the vehicle chassis or engine block away from the battery.
- Check that the jump starter and its cables, or any other object or person, are not in contact or near a mobile mechanism
inside the engine. (Belt for example).
- Start the vehicle.
CAUTION, MAKE SURE YOU DO NOT ACTIVATE THE STARTER FOR LON-
GER THAN 10 SECONDS.
- If several jump starts are necessary to start the vehicle, wait at least 3 minutes between two jump starts.
- Check that the charge level is sufficient between two jump starts.
- After the vehicle starts,
disconnect the black negative (-) clamp first
and store the cable and the clamp.
Then, disconnect the red (+) positive clamp and store the cable and the clamp.
7/ FUSE REPLACEMENT
The jump starter is equipped with a replaceable fuse, to protect the battery from overload.
Fuse Specification: Littelfuse BF2 series type, rated 32 V, 300 A.
WARNING! KEEP AWAY FROM SPARKS AND FLAME – BATTERY COULD
EMIT EXPLOSIVE GASES.
- Allow the fuse to cool down completely (approximately 5 minutes).
- Make sure the the unit is unplugged from any power source.
- Remove the negative (BLACK) clamp and cable from the cord/clamp holder on the side of the unit and locate the fuse cover.
- Follow the arrow to open the right side of the fuse cover, and then rotate the cover from right to left to remove it.
- Using a 13mm socket/wrench, remove both nuts and washers.
- Remove the open fuse and replace it with a new one of the same type and rating.
- Replace the nuts and washers and torque to 5,6 Nm (50 in-lbs).
- Replace the fuse cover.
- The unit is now ready to use.
8/ ACCESSORY/SPARE PARTS
Visit www.2helpU.com for accessories and spare parts.
9/ GUARANTEE
Your USAG JUMP STARTER is guaranteed 1 year from its invoice date against all manufacturing flaws.
List of exclusions of guarantee for USAG JUMP STARTERS.
• Jump starter open or which has been disassembled
• Short-circuit.
• Trace of electric arc on clamps.
• Reversed polarity.
• Continuous use for more than 10 seconds.
• Jump starter stored discharged.
• Cables and clamps are excluded from the guarantee.
• Jump starter charged with a charger other than the one supplied with it.
• Trace of shock or impact.
• Fuses
• Jump starter batteries are wear parts excluded from the guarantee. To increase the lifetime of the batteries, they must be
kept charged at all times.
DISPOSAL OF THIS ARTICLE
Dear Customer, If you at some point intend to dispose of this article, then please keep in mind that
many of its components consist of valuable materials, which can be recycled.
Please do not discharge it in the garbage bin, but check with your local council for recycling facilities
in your area.
